Menjual
Elastimold untuk JTM/TM Straight Connector, Elbow, Tee Connector untuk
pemasangan TRAVO dan Cubikle dengan berbagai merk dan ukuran
Screened elbow and straight connection system for gas-insulated switchgear and transformers with bushings according to EN 50181 type A (250A), 10 kV, 15 kV and 20 kV
Screened adapters are designed
to connect single-core polymeric cables
to gas-insulated switchgear or transformers up to 24 kV. The adapter seals on
bushings according to EN 50181 type A
(250A). Connection can be made in a
straight or right-angle configuration.
1. Screened body with integrated stress control
2. Capacitive test point
3. Earthing eye
4. Retainer connection point
5. Compression pin-connector
6. Rayvolve sealing system
Design
The thick walled adapter with an integrated stress control provides sealing and electrical connection to the cone of the bushing and the cable. Made of crosslinked EPDM and protected with a minimum 3 mm moulded conductive shield connected to earth, the adapter are suitable for both indoor and outdoor installations. The special design and material selection of the adapters allows the use on a wide range of cable dimensions. Thus the adapters are independent of cable tolerances and special cable adapters are not required. The cable preparation and cut-back dimensions are the same for straight or elbow adapters. The adapters are equipped with a capacitive test point to ensure that the circuit is not energised before disconnection. The capacitive test point is protected by a conductive cap. High strength bimetallic DIN-compression connectors tested to VDE 0220 are supplied within the kit to connect both aluminium and copper conductor cables
Installation After cable preparation and crimping of the connector, the adapter can be simply be slid into place under virtually all conditions. For elbow adapters, the connection pin is screwed into the connector, a hexagon wrench is provided with the kit. A separable mounting system allows an easy installation of the adapter to the bushing. To provide a reliable environmental seal between the adapter and the oversheath a cold-applied Rayvolve tubing or a heat-shrinkable phase marking tubing is offered.
The thick walled adapter with an integrated stress control provides sealing and electrical connection to the cone of the bushing and the cable. Made of crosslinked EPDM and protected with a minimum 3 mm moulded conductive shield connected to earth, the adapter are suitable for both indoor and outdoor installations. The special design and material selection of the adapters allows the use on a wide range of cable dimensions. Thus the adapters are independent of cable tolerances and special cable adapters are not required. The cable preparation and cut-back dimensions are the same for straight or elbow adapters. The adapters are equipped with a capacitive test point to ensure that the circuit is not energised before disconnection. The capacitive test point is protected by a conductive cap. High strength bimetallic DIN-compression connectors tested to VDE 0220 are supplied within the kit to connect both aluminium and copper conductor cables
Installation After cable preparation and crimping of the connector, the adapter can be simply be slid into place under virtually all conditions. For elbow adapters, the connection pin is screwed into the connector, a hexagon wrench is provided with the kit. A separable mounting system allows an easy installation of the adapter to the bushing. To provide a reliable environmental seal between the adapter and the oversheath a cold-applied Rayvolve tubing or a heat-shrinkable phase marking tubing is offered.